Philips CCX193AT - Manual (Page 38)

TO END PRESS EXIT
Press the Number buttons to enter the PlusCode pro­
gramming number of the program you wish to record (this
number is different for every program, and it can be four to eight
digits long). Finally, press the VCR PLUS+ button.
/vCR PLUS+ PROGRAM \
PLUSCODE: 60590--------------
TOSmr PRESS VCR +
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
To record the program once, press the Number I button
to select ONCE. To record the same program every day
from Monday through Friday, press the Number 2 button
to select DAILY. To record the same program every week
on the same day (such as every Saturday), press the
Number 3 button to select WEEKLY.
VCR PLUS+ PROGRAM ^
1 ONCE
2 DAILY {MON - FRI)
3WEBCLY
TO SELECT PRESS NUMBER
TO END PRESS EXIT
B
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
o The clock has been set. If not, CLOCK MUST BE SET appears. ’
o Channels are programmed.
o There is a tape in theTV/VCR. (make sure the tape’s record tab
Is intact and the tape is long enough to record the program),
o You have completed the steps on pages 36-37.
Complete each step within 60 seconds of completing the
previous step. If you don't, you may return to step I.
38 Timer Recording With the VCR
Plus*
Programming
System
Press the VCR PLUS+ button on the remote control.The on­
screen display shown below will appear.
/VCK
PLUS+ PROGRAM \
PLUS CODE:--------------------------
O
©CDCDe>i
CD CD CD
CD CD CD]
o O CD
Helpful Hints
• If the power fb//s, programmed timer
recordings will not be lost The pro­
grammed timer recordings will be
restored when the clock is reset after
the power failure. (The clock will
reset itself automatically if you are
using the AUTO CLOCK feoture.
Detoi/s are on pages 14- 17. if you
are not using the AUTO CLOCK fea­
ture, reset the clock manually; then,
the timer recording will be restored.
Detoi/s are on pages 12- 13.) The
timer recording will not occur only if
the timer recording was scheduled to
tote place during the power failure.
« You cannot set a timer recording if
the 7V/VCR is in Record Defeat
mode.To set the Record Defeat mode
to OFF, see page 40.
» If CODE ERROR flashes after you
enter the PlusCode programming num­
ber and press the VCR PLUS+ button,
the number you entered wos incorrect
(fl)r example, too short). If this hap­
pens, enter the correct number.
" CLASH may flash on the screen after
you complete step 2. This means that
the timer recording you just pro­
grammed and another timer recording
overlap, and thus the current timer
recording will not be carried out