Futaba 4PLS 2.4GHz FHSS - Manual (Page 85)

85
Fu
n
c
tio
n
ESC Link Function "MC LNK"
a
-Select the setting item "MODE" by the (JOG) button, and
select "READ" by (+) or (-) button.
b
-Select the setting item "EXEC" by the (JOG) button, and
press the (+) and (-) buttons simultaneously for 1 second or
longer.
-"COMPLETE!" blinks on the screen and the ESC type and currently set con-
tents are read.
- If "LINK ERROR" blinks on the screen, communication with the amp is not
being performed normally. Check the T4PLS and ESC connection and the
battery connection to ESC and the ESC power switch and repeat steps a b.
3
(Writing to ESC)
Execute this function to write the setting data to ESC. See
pages 84~85 for the setting data contents.
a
-Select the setting item "MODE" by the (JOG) button, and
select "WRITE" by (+) or (-) button.
b
-Select the setting item "EXEC" by the (JOG) button, and
press the (+) and (-) buttons simultaneously for 1 second or
longer.
-"COMPLETE!" blinks on the screen and the setting data is written to ESC.
If "LINK ERROR" blinks on the screen, communication with the amp is not
being performed normally. Check the T4PLS and ESC connection and the
battery connection to ESC and the ESC power switch and repeat steps a b.
In addition, if (NO DATA) is displayed on the T4PLS screen, "WRITE" cannot
be selected because there is no setting data to be written.
- Different type ESC data cannot be written. If writing is attempted, "TYPE
ERROR" will link on the screen to show that the ESC type is wrong.
4
(Initialization)
This function writes the MC setting data set at the factory to
the connected MC and T4PLS. Perform "READ" before per-
forming initialization.
a
-Select the setting item "MODE" by the (JOG) button, and
select "RESET" with the (+) or (-) button.
b
-Select the setting item "EXEC" by the (JOG) button, and
press the (+) and (-) buttons simultaneously for approximate-
ly 1 second
- "COMPLETE!" blinks on the screen and the initial data is written to the ESC.
If "LINK ERROR" blinks, communication with the amp was not performed
normally. Check the T4PLS and ESC connection and the battery connection
to ESC and the ESC power switch, and repeat steps a b. In addition, when
(NO DATA) is displayed on the T4PLS screen "RESET" cannot be selected
because there is no write initial data.