Futaba 4PLS 2.4GHz FHSS - Manual (Page 110)

Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Voltage alarm
3.8V~8.0V
Initial value: 5V
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value “0” by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
110
Fu
n
c
tio
n
Telemetry "TELEMETRY"
Receiver power sup-
ply voltage setting
Exter nal power
s u p p l y Vo l t a g e
sensor setting
Page1
Temperature sensor
setting
RPM sensor setting
Page2
Telemetry Sensor Setting
An audible alarm can be generated by the T4PLS from the data from a telemetry sensor.
This setting sets alarm ON/OFF and the alarm conditions.
Refer to the map on page 108 for the sensor setting (SENS MODE) screen display.
There are receiver power source (battery) voltage and external power source (drive bat-
tery) voltage settings on page 1 of the sensor setting screen and temperature and speed
settings on page 2. Pages 1 and 2 are switched by (JOG) button left or right operation.
(Setting of each item)
Setting the receiver power supply voltage alarm
Display page 1 by (JOG) button left or right
operation.
Select "ALRM" of the "*RX VOLT" setting
items by (JOG) button up or down operation,
and set alarm ON/OFF with the (+) button or (-)
button.
"OFF" : Alarm OFF
"ON" : Alarm ON by a voltage drop below the specified voltage
Select "VOLT" of the "*RX VOLT" setting items by (JOG) but-
ton up or down operation, and set the voltage at which the
alarm begins to sound with the (+) button or (-) button. The
number of digits can be shifted by (JOG) button left or right
operation.
When ending, move the cursor to [RT] by the (JOG) button,
and return to the HOME screen by pressing the (JOG) but-
ton twice.
Setting method