Futaba 4PLS 2.4GHz FHSS - Manual (Page 73)

The function select switch
screen (P65) can be dis-
played from this screen.
< NO SW >
I f f u n c t i o n ’s O N / O F F
switch is not selected,
is displayed.
73
Fu
n
c
tio
n
4WS Mixes “4WS”
1
(4WS type selection)
Select the setting item "MODE" by the (JOG)
button up or down operation. Use the (+) or
(-) and set the function to the “ON” or “OFF”
state.
"INH" :Function OFF (front only)
"2TYP" :Front side only, reverse phase switching
"3TYP" :Front side only, reverse phase and same phase switching
"4TYP" :Front side only, reverse phase, same phase, and rear side only switching
Switched in the order shown in the figure below by set SW
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
"2TYP" Front side only and reverse
phase switching
"3TYP" Front side only, reverse phase, and same phase switching
"4TYP" Front side only, reverse phase, same phase, and rear side only switching
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) but-
tons simultaneously (approx.
1 sec).
2
(Rear side travel adjustment)
Select setting item "RATE" by the (JOG) button up or down
operation. Adjust the rear side travel with the (+) or (-) but-
ton.
3
(Mix mode setting)
Select setting item "MXMD" by the (JOG) button up or down
operation. Set the mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"ON" :The EXP function o the 1st CH and other settings are mixed.
4
When ending, return to the MENU screen by moving the cur-
sor to the positions other than SW/DIAL and pressing the
(JOG) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.