Caution, Set contents – Futaba 4PLS 2.4GHz FHSS User Manual

Page 14

for
e

Using

$IWHURSHQLQJWKHER[¿UVWFKHFNLIWKHFRQWHQWVFRQIRUPWRWKHIROORZLQJ7KHFRQWHQWV
depend on the set as shown below.

Set Contents

Transmitter

T4PLS

Receiver

R304SB

Miscellaneous

Dry battery holder

*Installed in transmitter.

Receiver switch

Mini screwdriver

* It is used for R304SB.

Instruction manual

- If any of the set contents are missing, or you have any questions, please contact
your dealer.

Caution

￸ Always use only genuine Futaba transmitters, receivers, servos, ESCs (electronic speed con-

trols), NiMH, NiCd, Li-ion batteries and other optional accessories.

Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts speci-
ﬁed in the instruction manual and catalog.

￸ When using the T4PLS in the T-FHSS (HIGH) and S-FHSS (HIGH) mode, always use it under the

following conditions:

Servos :Futaba digital servo (including BLS Series brushless servos)

Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).

Transmitter mode :RX MODE (See p.29 for setting method.)

Under other conditions, the set will not operate, or the speciﬁed performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.

In addition, the FSU Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the trans-
mitter.

￸ When using analog servos, always switch the T4PLS servo response to the "NORM" mode.

Transmitter mode :"T-FHSS(NORM)", "T-FHSS(NORM)"and FHSS mode (See p.29 for setting method.)

Receiver’s battery :Matched to the ratings of the receiver and connected servo (dry cell battery cannot be used).

The set cannot operate in the "HIGH" mode. Operation in this mode will cause trouble with the servo and other equipment.

Digital servos (including BLS Series brushless servos) can also be used in the "NORM" mode.