Futaba 4PLS 2.4GHz FHSS - Manual (Page 115)

115
Refer
e
nce
Reference
Ratings
6SHFL¿FDWLRQVDQGUDWLQJVDUHVXEMHFWWRFKDQJHZLWKRXWSULRUQRWLFH
 Caution
Communication method:2QHZD\RSHUDWLRQV\VWHP
Maximum operating range:P2SWLPXPFRQGLWLRQ
For safety: )6%)6,'
Transmitter T4PLS-2.4G
7)+666)+66)+66V\VWHPZKHHOW\SHFKDQQHOV
Transmitting frequency:
*+]EDQG
Power requirement:
'U\FHOOEDWWHU\3HQOLJKW[9
Current drain:
P$RUOHVV
Transmission antenna:
ȜGLSROH
Receiver R304SB: 7)+66V\VWHPFKDQQHOV
Power requirement:
9a9EDWWHU\a9XVHDEOH
'U\FHOOEDWWHU\FDQQRWEHXVHG
Receiving frequency:
*+]EDQG
System:
7)+66V\VWHPDXWRGHWHFWLRQ
Size:
[[[[PPH[FOXGLQJDSURMHFWLRQSDUW
Weight: R]J
￸ When using the T4PLS in the T-FHSS (HIGH) and S-FHSS (HIGH) mode, always use it under the
following conditions:
Servos :Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
Transmitter mode :RX MODE (See p.29 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the trans-
mitter.
￸ When using analog servos, always switch the T4PLS servo response to the "NORM" mode.
Transmitter mode :"T-FHSS(NORM)", "T-FHSS(NORM)"and FHSS mode (See p.29 for setting method.)
Receiver’s battery :Matched to the ratings of the receiver and connected servo (dry cell battery cannot be used).
The set cannot operate in the "HIGH" mode. Operation in this mode will cause trouble with the servo and other equipment.
Digital servos (including BLS Series brushless servos) can also be used in the "NORM" mode.