Futaba 4PLS 2.4GHz FHSS - Manual (Page 103)

Battery Type (BATT)
DRY4, N5/L2
Buzzer tone (BUZZER)
OFF, 1~100
Initial value: 85
Voltage display
When BATT is set to dry cell
use DRY4 or LiFe2/NiMH5,
the voltage display of the
HOME screen changes.
DRY4 LiFe2, NiMH5
103
Fu
n
c
tio
n
(Setting the battery type)
Select the setting item "BATT" by the (JOG)
button, and select the mode by pressing the
(+) or (-) button. When changing the battery
type, press the (JOG) button after thorough-
ly checking whether or not the mistake was
made again. An electronic beeping sound is
generated and the setting is changed.
Note: If the battery type is changed to the wrong setting, the
low battery alarm will be generated immediately after the
change and operation will become impossible.
When the low battery alarm was generated, turn off the power and replace the bat-
tery with a fully charged battery or a new dry cell battery and then reset the battery
type.
Note: If used with the incorrect setting, a normal low battery alarm will not be gen-
erated and the system may stop before the battery alarm is generated. The usage
time may also become extremely short.
"N5/L2" :Futaba LiFe type battery (FT2F1700B/2100B)
"N5/L2" :Futaba MiMH type battery (HT5F1800B)
"DRY4" :Dry cell battery (alkaline battery recommended) 4 batteries
System Functions "SYSTEM"
When ending, return to the menu screen by
pressing the (JOG) button.
(Adjusting the buzzer tone)
Select the setting item "BUZZER" by the (JOG)
button, and use the (+) and (-) buttons to adjust
the tone.
- Decide by referring to the tone at adjustment.
When ending, return to the menu screen by
pressing the (JOG) button.