Flintec FAD-40 - Manual (Page 34)

FAD-40 Technical Manual, Rev. 1.06 December 2012 Page 34 of 52
PLC Output to FAD-40CO Input
Dword
D31 D30 D29 D28 D27 D26 D25 D24 D23 D22 D21 D20 D19 D18 D17 D16
D15 D14 D13 D12 D11
D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
RxPDO 1
(R_DW1)
Reserved
RxPDO 2
(R_DW2)
W31
MSB
W30 W29 W28 W27 W26 W25 W24 W23 W22 W21 W20 W19 W18 W17 W16
W15 W14 W13 W12 W11 W10 W9 W8 W7 W6 W5 W4 W3 W2 W01
W00
LSB
RxPDO 3
(R_DW3)
Not used
I/O3
out
I/O2
out
I/O1
out
Not used Command List Data Selection
New
CMD
PLC Output to FAD-40CO Input R_DW2
R_DW 2contains the setting / parameter value (Refer to “Adjust span calibration” and “I/O configuration” in
“Command List”, see PLC Output to FAD-40CO Input R_DW 3).
I/O Configuration
Bit no. R_DW_2 description
D0…D6 I/O1 output function
0000000 Disable
0000001 Standard setpoint
0000010 Setpoint without hyster.
0000011 Window
0000100 Host output
D7 I/O1 polarity
0 Active Low
1 Active High
D8…D14
I/O2 output function
0000000 Disable
0000001 Standard setpoint
0000010 Setpoint without hyster.
0000011 Window
0000100 Host output
I/O2 input functions
0000101 Zeroing
0000110 Taring
0000111 Clearing tare
0001000 Host input
D15 I/O2 polarity
0 Active Low
1 Active High
D16…D22
I/O3 output function
0000000 Disable
0000001 Standard setpoint
0000010 Setpoint without hyster.
0000011 Window
0000100 Host output
I/O3 input function
0000101 Zeroing
0000110 Taring
0000111 Clearing tare
0001000 Host input
D23 I/O3 polarity
0 Active Low
1 Active High