Flintec FAD-40 - Manual (Page 33)

FAD-40 Technical Manual, Rev. 1.06 December 2012 Page 33 of 52
FAD-40CO Output to PLC Input T_DW3
Bit no. TxPDO 3 (T_DW3) Description
D31…D21 Not in use
D20 Input for I/O2
D19 Input for I/O3
D18 Output for I/O3
D17 Output for I/O2
D16 Output for I/O1
D15…D12
Error codes of
converter
0000 No error found
0001 ADC out
0010 ADC over
0011 ADC under
0100 System error
0101 In setup mode
0110 Low/High voltage error
0111 Instrument not found
D11…D10 Not in use
D9 Operation mode
0 Weight & Force Mode
1 Count Mode
D8 Zero range
0 Weight is out of zero range
1 Weight is in zero range
D7 Indication
0 Gross
1 Net
D6
MD –
Motion detection
0 Stable
1 Unstable
D5
D4
D3
D2
D1
Read command
response
00000 Indicated weight
00001 Gross weight
00010 Tare weight
00011 Indicated weight (floating point type)
00100 Gross weight (floating point type)
00101 Tare weight (floating point type)
10000 Calibration Status (Refer to table 8.2)
D0 CMD flag The command is applied successfully