Configuring device properties, Ties, see – Comtrol DeviceMaster NS-Link User Manual
Page 38
38 - Configuring Device Properties
DeviceMaster Driver User Guide: 2000595 Rev. A
NS-Link Device Driver Configuration
Configuring Device Properties
Use the following procedure to change device settings on a
1.
Open Comtrol Drivers Management Console (
2.
Highlight the
device name that you want to configure.
3.
If desired, change the User-Friendly Device Name.
4.
Optionally, set a different
(Page 39) period. You can set the
amount of time in seconds that this DeviceMaster waits until it closes this
connection and frees all the ports associated with it.
Note: This value may be set to less than 5 seconds, however the DeviceMaster
may not operate at any value less than 5. A recommended value to begin
experimentation with is 10.
5.
Optionally, set the
(Page 40) value.
Note: This value should not be modified unless the network connection to the
DeviceMaster is very slow, such as, if a satellite uplink connection is
involved. It is recommended that a value over 3 never be used.
6.
Optionally, click a different
7.
Optionally, click Verbose Event Log if you want to log additional DeviceMaster
information into the event log.
8.
After making your changes, click Apply if you have additional configuration
procedures or click Ok if you have completed configuring your Comtrol devices.
Note: If you do not Apply the changes, you will be prompted to Apply, Ignore, or
Cancel the changes.
The following table provides detailed information about Device General tab options
for the DeviceMaster.