Adding a devicemaster (existing installation) – Comtrol DeviceMaster NS-Link User Manual
Page 25
DeviceMaster Driver User Guide: 2000595 Rev. A
Adding a DeviceMaster (Existing Installation) - 25
NS-Link Device Driver Installation
Adding a DeviceMaster (Existing Installation)
Use the following procedure to add aDeviceMaster to an existing
installation.
1.
Close any applications that are using serial ports before the device driver
installation.
2.
Connect the DeviceMaster to your network and use PortVision DX to program
the IP address.
If you need hardware installation procedures, see
Do not connect RS-422/485 devices until the appropriate port interface
type has been configured in the device driver. The default port setting
is RS-232.
3.
From the Start button, click Program> Comtrol> DeviceMaster> DeviceMaster
Driver Installation Wizard.
4.
Click Next to start the Comtrol Driver Installation Wizard.
5.
Click Install and Next.
6.
Click Next and follow the Installation Wizard. Refer to Step 8 on Page 18, for
the remainder of the installation steps if needed.
Caution