Toshiba TEC FDS-50 - Manual (Page 91)

EOl-11005
5. TERMINAL REPORTS
The following table shows the key operation to take each report. The “X” and “Z” reports have
exactly the same print content if both are available, except that:
1. The “X” reports allow to read the sales data but not clear memories, while the “Z”
reports allow to read the sales data and at the same time ail the resettable memories wilt
be cleared when the reports have been issued.
2. The symbol “Xnn” is printed on the top line of an “X” report, while “Znn” is printed on a
“Z” report, (“nn” is the Report No.)
3. A reset count is printed on the bottom of a “Z” report only.
4. When multiple terminals are connected on one in-line cable (Master-Satellite System),
Terminal Daily Z reports of each terminal are usually taken by report collection commands
on the Master Terminal. Accordingly, those Z report takings can only be operated on
each terminal with an appropriate system option selection and with an entry of the “Off­
line Reset Code” prior to the key operation to take each Z report. (Mode Lock: Z,
|Code| [#D
TABLE OF OPERATIONS FOR TERMINAL X AND Z REPORTS
Terminal Daily Reports (GT Lock: Neutral)
REPORT
HEADER
REPORT NAME
MODE
LOCK
KEY OPERATION
SAMPLE
PAGE
X03
Z03 FINANCIAL Read
FINANCIAL Reset X
z
3[CASH] 12,13
X04
Z04 CATEGORY & DEPARTMENT Read
CATEGORY & DEPARTMENT Reset
X
z
4[CASH] 14
X05
Z05
ALL MENU ITEM Read
ALL MENU ITEM Reset X
z
5 [CASH] 15
X05 Designated Category Menu Item Read X |Cateaorv Code| [#] 5 [CASH] 16
X05
Designated Department Menu Item
Read
X |Deot Code] fNSl 5 fCASHl 16
X05 Zone Menu Item Read X
|Zone-start Item Code| fO/FORl
i
|Zone-end Item Code| fi5)/FORl
i
5 [CASH]
16
X05 Individual Menu Item Read X
[Code-preset Menu] -----------------
for Item Code| flTEM #1)
i
([ST] for subtotal) ---------------
[CASH] to end
16
X06
Z06 HOURLY RANGE Read
HOURLY RANGE Reset
X
z
6 [CASH] 17
COMBINATION READ REPORTS
COMBINATION RESET REPORTS
X
z
[CASH] ... for Table 1
1 [CASH] ... for Table 2
2 [CASH] ... for Table 3
- 9 -