Toshiba TEC FDS-50 - Manual (Page 74)

E01-11005
13. PAPER ROLL REPLACEMENT AND OTHER
MAINTENANCE OPERATIONS
Fig. 2
13-1 INSTALLING THE RECEIPT PAPER
1. Turn the Mode Lock to the REG position with the
power ON.
2. Remove the Paper Cover, and remove the Journal
Winding Reel {Fig. 1),
3. Place a new paper roll in the direction shown in Fig. 2
so that the paper end will be fed from the bottom.
4. Fold the paper end as shown in Fig. 3 to ease the
insertion.
5. Place the paper roll in the outer holder of the two roll
holders {Fig. 4).
6. Insert the paper end into the Receipt Inlet, feed the
paper in while pressing down the Free Lever (or feed
the paper in while pressing the [RF] key). (Fig. 5)
7. When the whole folded portion has come out, tear off
the unnecessary part with an appropriate end length
remaining (approx. 5 cm or 2 inches). (Fig. 6)
8. Go on to INSTALLING THE JOURNAL PAPER steps if
necessary, or go on to Step 9 below if not.
9. Attach the Paper Cover. Please note the paper end
must be visible outside the cover.
10. Press the [C] key to clear the paper-end condition, and
depress the [NS] key to issue a receipt to check if the
paper has been properly set.
NOTE: The [RF] or [JF] keys function only when both
receipt and journal paper rolls have been placed
in their respective holders.
Free Lever
Inlet
Fig. 5
Approx. 5cm
Fig. 6
71 -