Toshiba TEC FDS-50 - Manual (Page 11)

EOl-11005
(3) Error Messages {in any mode except “LOCK”)
When an error occurs, a 2-digit error code and its message (programmable) are
displayed, with an error buzzer (a long tone).
Read the Error Code or the Error Message, depress the [C] key to cancel the
error status and tone, operate the sequence again after removing the cause of
the error.
The following table shows the cause of the error corresponding to each Error
Code. Fill in the actual content for the Error Message programmed for your
terminal. (The manager should have the information.)
ERRCR CCDE AND MESSAGE TABLE
Error
Code
Error Message Content or Cause of Error
01 Operation error
02 Operation locked
03 illegal programnning
04 Incorrect code entry
06 Numeric entry overflow
07 Numeric entry inhibit error
08 Numeric entry compulsory error
09 Manager intervention required
10 Validation required
11 Validation operation error
12 Drawer -close compulsory
14 Code entry compulsory error
16 Scale entry compulsory error
17 Scale operation error
18 Scale time-out error
20 Guest Check insertion required
21 Guest Check removal required
22 Remote Kitchen Printer busy
23 Remote Kitchen Printer off-line
24 Remote Kitchen Printer hardware error
25 Server # required
26 Check # required
27 Guest # required
28 Table # required
29 Operator busy
30 Sign ON required
31 Incorrect operator code
32 Previous Balance file busy
33 Previous Balance file full
34 Incorrect Check #
35 Check Transfer operation
36 Communication error
37 Time-Out Error (on Satellite Terminals)
38 Transmission Error (on Satellite Terminals)
39 The server still has outstanding checks.
40 Power Failure occurred (See Chapter 10.)
It is recommended io prepare a copy of the above table after filling in the messages, and place it
near the register.
-8-