Toshiba TEC FDS-50 - Manual (Page 70)

EOl-11005
Power Switch ................... When the Power Switched is turned ON, the printer starts
initializing, and the print head returns to the home position.
LINE Lamp ....................... It is lit when the printer is in on-line condition. It goes out
when the printer is in off-line condition. Printing is possible
when the LINE lamp is lit.
ALARM Lamp ................... It lights up when a paper-empty error has occurred, it flickers
when a hardware error such as motor lock has occurred. It
goes out when the cause of the error is removed or cleared.
LF Switch ......................... It must be pressed when paper feeding is necessary.
LINE Switch ..................... It must be pressed to reverse the printer condition from on­
line to off-line, or vice versa.
Paper End Detector
A paper-end detector is installed in the printer, and a paper-end condition is indicated in
the following steps:
(1) The ALARM lamp turns lit.
(2) The ON LINE lamp goes out.
(3) The alarm buzzer sounds.
When paper is refilled, the alarm buzzer stops and the ALARM lamp goes out.
Print and Cut Positions
Cut Position
Terminal Operation and RKP Printing
A maximum of 4 Remote Kitchen Printers (RKP-50) can be connected to the terminal via
the TIP NET cable. Each of the remote printers should be placed in a preparation area
such as kitchen, pantry, etc. According to the status “Printer Destination 1 to 4” of each
menu item, the menu item entry is printed on the designated remote printer in order
sequences {accurately on depressing the [TOTAL] key to end the order sequence In Tab
Mode or on finalizing the transaction in Non-tab Mode), if multiple menu items data are
sent to one remote printer, the Print Priority set for each item decides the printing order.
- 67 -