Toshiba TEC FDS-50 - Manual (Page 75)

EOl-11005
Fig. 8
Journal Inlet
Fig. 9
13-2 REMOVING THE RECEIPT PAPER
^. Remove the Paper Cover.
2. Tear the paper end off the paper core and pull the
paper end out while depressing the Free Lever. (Fig. 7)
3. Remove the paper core.
Fig. 7
13-3 INSTALLING THE JOURNAL
PAPER
1 .
2 .
3.
4.
5.
6 .
7.
8 .
Turn the Mode Lock to the
power on. ‘REG” position with the
Remove the Paper Cover by pulling it upward, and
remove the Journal Winding Reel. (Fig. 1)
Follow Steps 3 and 4 of INSTALLING THE RECEIPT
PAPER procedure on the preceding page.
Place the paper roil in the inner roll holder of the two
holders. (Fig. 8)
Insert the paper end into the Journal Inlet, feed the
paper in while pressing down the Free Lever (or feed
the paper in while pressing the [JF] key. (Fig. 9)
When a sufficient amount of paper comes out, wind the
paper around the Journal Winding Reel two or three
times, and set the Journal Winding Reel into the Reel
Holder. (Fig. 10)
Attach the Paper Cover.
Press the [C] key before starting operation.
13-4 REMOVING THE JOURNAL
PAPER
1. Remove the Receipt Cover.
2. Press the [JF] key to wind up enough of the journal
paper, and then tear off the paper, holding the Journal
Winding Reel.
3. The wound-up portion of the paper can easily be
removed from the Reel by pulling it sideways. (Fig. 11)
4. If enough paper remains on the roll, follow Steps 6
through 8 above; if the paper is running out, follow
Steps 1 through 8 above.
NOTE: The [JF] or [RF] keys function only when both
journal and receipt rolls have been placed in their
respective holders.
- 7 2 -