Toshiba TEC FDS-50 - Manual (Page 76)

EOl-11005
13-5 REPLACING THE RIBBON
CARTRIDGE
If either the receipt or journal print is too light, replace the
Ribbon Cartridge in the following manner.
1. Remove the Ribbon Cover (Fig. 1).
2. Remove the old Ribbon Cartridge by pulling it toward
you (Fig. 2).
3. Install a new Ribbon Cartridge in the reverse order to
Step 2 above (Fig. 3).
4. The Ribbon Cartridge is a consumable product. Be
certain to use a genuine Ribbon Cartridge supplied by
your TEC representative.
13-6 REPLENISHING THE STORE
NAME STAMP WITH INK
When the store name stamp is printed too lightly, replenish
the ink in the following manner:
1. Turn the Power Switch to OFF. Remove the Paper
Cover.
2. Withdraw the store name stamp with the protruding
part clasped between your fingers (Fig. 4).
3. Apply ink to the pad on the rear side of the Store
Name Stamp. The amount applied should be adjusted
according to the desired darkness of the printed
message, but the limit of 2 cc should not be exceeded.
(The ink bottle supplied contains 5 cc of ink.) (Ftg.5)
4. Follow the reverse order of the instructions in Step 2,
and then attach the cover.
Ink
Fig. 5
Fig. 4
- 73 -