Toshiba TEC MA-85-100 - Manual (Page 71)

EOI-11072
3. If an hour value of more than 23 or a minute value of more than 59 is set, it will
not result in an error but the data will not be processed into that hourly range.
4. To change the table of hourly ranges once set, partially or entirely, do the
entire setting operation over again.
5. To clear the hourly range table once set, operate in SET mode
0
©/FOR
- B -
#/CID
-►
AT/TL
Example):
Hourly Range Table
up to 8:00
8:00 to 9:00
9:00 to 10:00
10:00 to 13:00
13:00 to 16:30
1630 to 18:00
Selecting PrInt/Non-print Uems on Reports
The following table shows the items on reports that can be programmed to be printed or non-
printed according to your store’s requirements. For further details of programming, refer to
Chapter “17. System Option Setting”. If you have started operations on the register without
this programming operation performed, print or non-print status of each Item is determined by
the “Initial Status” in the following table. It is recommended, therefore, to change Print/Non-
print status of each item after once taking all the reports.
Item
Initial Status
Before Change
System Option
Address No. - Bit No.
GT (Grand Total) Print Address 1 - Bit 4
Sum of Negative Departments Non-print Address 1 - Bit 6
Sum of Ali Departments Non-print Address 11 - Bit 2
Net Sale With Taxes Print Address 13 - Bit 1
Net Sale Without Taxes Non-print Address 13 - Bit 2
Receipt Consecutive No. on Journal or every
Receipt
Print Address 15 - Bit 2
Receipt Consecutive No. Resetting Non-resettable Address 15 - Bit 3
- 7 1