Toshiba TEC MA-85-100 - Manual (Page 70)

EOl-11072
16. Read and Reset Reports
This chapter describes the operation to take each report and its contents. The
report function is one of the most beneficial features of this register. As sales
data are entered, the register processes the data into appropriate totals and
counters in the report memory. The reports are not only a form of sales data
records but will also be a valuable guide to a more prosperous future of your
store if you fully utilize and analyze them.
Programming Operations Reiating to Reports
Programming Hourly Range Table
The “Hourly Sales Report” is available as part of the report function. However, sales data
entered in REG mode are processed into Hourly Ranges only after programming an Hourly
Range Table. If you have started operations on the register without this programming
operation performed, the “Hourly Sales Report” cannot be taken. The Hourly Sales Report
table must be programmed in order to obtain Hourly Sales Reports for the day and thereafter.
Condition: After Hourly Sales Reset
(refer to ''NOTE on Condition" on page 20)
Programming Procedure:
Use the MA Key to turn the
Control Lock to “SET”.
REG
OFF
SET
0
©/FOR
Declaration of Program
No. 7 for Hourly Range Table
programming
Repeat for sertng next Hourly Ranges (max. 24 hourly ranges)
Hour
(0 to 23)
Minute
(00 to 59)
or
#/CID
#/NS
►
---------------- Y-------
Enter the time that ends the Houriy
Range, in the 24-hour system using
the military time. (The time to start is
the time entered for the preceding
Hourly Range.)
(See NOTES 2, 3)
NOTES 1. A maximum of 24 hourly ranges may be set
2. Do not set an hourly range across 24:00, such as "from 23:00 to 1:00”. Such
setting does not cause an error in programming but the sales data will not be
processed into that hourly range.
- 7 0 -