Kenwood TS-850S User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4-11-11. Mode and Filter Changes during
Memory Channel Operation (00-
89ch)
Modes and filters can be changed during memory
channel operation, but, with the exception of the
transmit / receive frequencies, the contents of
memory channels for the selected memory channel
cannot be changed.
4-11-12. Clearing a Memory Channel
To erase a specific Memory Channel:
Press and hold the CLR key for approximately 2
seconds or transfer data from an empty Memory
Channel to the Memory Channel you wish to clear.
4-11-13. Quick Memory Channel
There are five quick memory channels in total.
Quick Memory Channel is capable of storing the
following information.
Receive frequency, mode and filter
Transmit frequency, mode and filter
RIT ON/OFF, XIT ON/OFF, AlP ON/OFF,
FINE ON/OFF, TUNE ON/OFF, 1 MHz key ON/OFF,
Select the meter indicate.
■Quick Memory Channel Entry
[1] Memory entry when the VFO operation.
1. Select the receive frequency, the mode and the
filter.
2. Press the M.IN key of QUICK MEMO. The data is
written to quick memory channel 1.
Note
If RX VFO or TX VFO or both are M.CH, data
cannot be written.
3. This is a stacking memory. If there is already data
in channel 1, it is moved automatically to channel
2. If there is data in channel 2, it is moved
automatically to channel 3 and so on. If there is
data in channel 5, it is erased automatically.
[2] Memory entry when the Quick Memory Channel
operation.
1. When the quick memory channel is recalled, the
frequency, the mode, or other data in the memory
channel can be modified.
2. To store the modified frequency or the mode in
memory, press the QUICK MEMO M.IN key. The
contents of the memory channel are replaced with
new data. The original contents of the memory
channel are automatically moved to the next
memory channel. For example, if channel 3 is
recalled, the frequency or the mode modified, and
the QUICK MEMO M.IN key pressed, the new
data is stored in channel 3, and the original
contents of the memory channel are automatically
moved to channel 4. If channel 5 is recalled, the
frequency or mode modified, and the QUICK
MEMO M.IN key pressed, the new data is stored
in channel 5, and the original contents of channel
5 are automatically erased.
■Quick Memory Channel Recall
If the MR key is pressed and the M.CH/VFO CH
control turned, a quick memory channel can be
recalled. The frequency and mode can be modified,
but if you move to another channel or VFO and then
return to the original channel, the frequency and
mode return to the original values stored in the
memory channel. To return to VFO operation, press
the MR key again. To shift the quick memory
channel contents to the VFO, press the M^ VFO key.
Note
If all quick memory channels are empty, nothing
happens even when the QUICK MEMO MR key is
pressed.
40