Kenwood TS-850S - Manual (Page 11)

@ Meter
During receive the meter is used as an S-meter.
During transmit the meter is used as a POWER
meter, and is controlled by the METER key, and
provides either VSWR, COMP level or ALC level
readings.
The meter can be used as a peak hold meter.
Please refer to Section 4-10-15.)________________
Note
One or two segments of the S meter may light
when there is no signal, due to atmospheric noise.
(8) Filter indicators
Indicates which filters have been selected.
( 9 ) M.CH (Memory channel) display
Turns ON during a Memory Channel operation.
PRO (Program) display
Lights during selection or operation on memory
channels 90 to 99.
SCAN display
Turns ON during scanning.
M.SCR (Memory scroll) display
Lights when the M.IN key is pressed. When the
memory scroll function is active you can review
the contents of the memory channels without a
loss of the incoming receive frequency.
PITCH display
Lights when the PITCH function is ON.
SPLIT display
Turns ON during split operation.
F.LOCK display
Lights when the F.LOCK key is ON.
RIT display
Turns ON when using RIT.
XIT display
Turns ON when using XIT.
( 10 ) Frequency display
Indicates the operating frequency. The 10 Hz digit
may be suppressed. (Please refer to Section 4-10-
15.)
(i])Memory Channel number display
Memory Channel Number is displayed.
The • display indicates the Memory Channel
currently in the display will be skipped during
Memory Channel scan.
(§)ON AIR indicator
Lights during transmit.
(@ AT TUNE (Antenna Tuner) indicator
Lights to show that the automatic antenna tuner is in
operation. Do not attempt to operate further until it
goes off.
(g) AIP(Advanced Intercept Point) indicator
Lights when the AlP switch is ON.
(@MHz indicator
Lights when the 1 MHz key is ON.
(17)
NOTCH indicator
Lights when the NOTCH switch is ON.
(i|) LSB indicator
Indicates the LSB has been selected.
USB indicator
Indicates the USB has been selected.
CW indicator
Indicates the CW has been selected.
CW-R indicator
Indicates the CW-R(Reverse) has been selected.
FSK indicator
Indicates the FSK has been selected.
FSK-R indicator
Indicates the FSK-R(Reverse) has been
selected.
FM indicator
Indicates the FM has been selected.
FM-N indicator
Indicates the FM-N(narrow) has been selected.
AM indicator
Indicates the AM has been selected.
TUNE indicator
Indicates the TUNE has been selected.
FINE indicator
Indicates the FINE tuning has been selected.
TONE indicator
Indicates the TONE function has been selected.
11