2. initial setting – Kenwood TS-850S User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4-2. INITIAL SETTING
Prior to operation ensure the following switches and
controls are set as indicated in the figure below:
pT| Ensure the POWER switch is OFF.
[Y] An antenna must be connected.
Caution
Never transmit without the antenna connected.
[
4
] The DC power cable is connected.
Ensure the front panel controls and switches are
set as shown in the figures above.
3 A ground must be connected.