Buttonholes h ~ @ (continued) – Kenmore 19501 User Manual

Page 69

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Buttonholes H ~ @ (Continued)

• Adjust the Stitch Density

You can adjust the stitch density of the entire

buttonhole or of only one side.

The stitch length button controls the stitch

density. It IS pre-set at "0.4"-

Set the Machine

SECTION 5. LEARN THE STITCHES

1 3 E O S i

Stitch Density m Entire Buttonhole:

Press

adjust

the

stitch

density

the entire buttonhole.

For Condition A;

Lett Side Stitches too Far Apart
(see above)

Turn the feed balance dial slightly

toward

Use

the

large

screw

driver in your accessory box.

For Condition B:

Right Side Stitches too Far Apart
(see above)

Turn the feed balance dial slightly
toward "+"

After adjusting the feed balance dial, sew another test buttonhole to be sure
your adjustment is correct.

NOTE; Remember to turn the feed balance dial to the standard mark

{ ► ) when you have completed your buttonholes.