Section -2: pfiepabe, Prepare the bobbin (continued), Scnsorseui 70 – Kenmore 19501 User Manual
Page 21: El cdci] cidcidmm
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
; .SECTION -
2
:
PfiEPABE >
Prepare the Bobbin (Continued)
Sil
ScnsorSeui 70
SECDBCI]
QBC
l
]
El CDCI]
ciDCiDmm
NOTE:
The Pattern Indicator will read "SP" to show the machine is
winding the bobbin.
7.
Press the foot control gently to start the machine.
NOTE; After the bobbin ¡s slightly filled, stop and clip the thread coming
from the top of the bobbin.
8 . Slowly start the machine again and wind the thread until the bobbin
stops.
10. Remove the bobbin.
11. Push in the clutch to put power back into the needle.
NOTE:
If you do not push in the clutch, the machine will not run when
you press the toot control.
20