Kenmore 19501 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

' SECTiON 2. PREPARE YOUR MACHINE FOR'SEWiNG

Prepare the Bobbin

• Put Thread on the Spool

spool.

You have two spool holders;

large (under the top cover) and small

(in your accessory box).

1. Choose the appropriate spool holder.

Place your thread on the spool pin and

then fit the spool holder down over it,

so that the thread winds toward the

back of the machine, as shown.

Press the spool holder against the spool.

Lower the spool into the well.

To Use This Extra Spool Pin;

Fit the square end of the spool pin into the square hole, as shown.

Fit the spool pm felt on the base of the spool pm.

Put your spool of thread on top of the felt, with the thread winding in the

direction shown. See directions for winding the bobbin, p. 19

20.