Sew on heavy fabrics – Kenmore 19501 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 4. PRACTICE COMMON STlTGHINgSKlLLS J
Sew on Heavy Fabrics
Use the Darning Plate
Use this skill when sewing from 3 to 12 layers of fabric, such as sewing over
welt seams when hemming jeans.
1 . Use Foot A (Zigzag foot! with the black spring button.
NOTE:
This black button locks the foot so it does not give with the fabric.
2.
Sew as usual.
3. When your needle reaches the point where the fabric layers increase,
stop.
4.
Lower the needle and raise the presser foot.
5.
Press and hold the black button as you lower the presser foot.
6 . Release the black button and continue sewing.
To Put on the Darning Plate:
NOTE; The rectangular holes in the Darning Plate match the holes m the
needle plate. In the darning plate, these holes are slightly to the
right of center.
1.
Position the darning plate with the pins on the bottom.
2.
Fit the darning plate pins into the needle plate holes at the
5/8" mark. The feed dogs will show through the darning plate
holes.
Use the darning plate in the following ways:
Basting (P^)
Darning (P,
Button Sewing (P. 39)
36