Carl Goldberg GBGA0055 - Manual (Page 7)

7
5. ■ ■ Glue the remainder of the stab frame and install
another 1/16” balsa sheet. Then, trim the sheeting to
the profile of the stab.
■ ■ Spin the cut-off around and glue to the remaining space
on the frame.
■ ■ Flip the stab over and sheet it as shown above.
ELEVATOR CONSTRUCTION (4 Steps)
1. ■ ■ Collect all of the par ts needed to build the two
ELEVATOR HALVES. They include:
(5) 5/16” sq. x 16” BALSA STICKS PT. #4370
(1) BIRCH PLY D/C SHT. 5518 CONTAINING:
(4) HORN MOUNTS PT. #3481
(1) D/C BALSA SHT. 5520 CONTAINING:
(2) HORN MOUNT CORES PT. #3332
(2) D/C SHT. 5517 (BALSA) CONTAINING:
(1) BALSA CORNER GUSSETS PT. #3331
(1) BALSA HORN MOUNT CORES PT. #3331
2. ■ ■ Laminate the two 1/32” PLYWOOD HORN MOUNTS to
the 3/16” and 1/16” BALSA CORES.
■ ■ Make two such assemblies, one for each elevator half.
THIS COMPLETES THE HORIZONTAL STABILIZER. PUT IT
ASIDE FOR NOW; YOU WILL NOT NEED IT UNTIL YOU ARE
READY TO INSTALL THE HINGES.