Carl Goldberg GBGA0055 - Manual (Page 20)

20
22. ■ ■ Drill a 5/16” diameter hole at the center mark of both
discs. Then, slide the dowel through the Leading Edge,
the support, and the dowel guide.
■ ■ Insert the remaining front portion of Rib #1 onto the
dowel. Generously EPOXY the entire front rib area, as
well as the dowel support tabs in Rib #2.
23. ■ ■ Crack off all of the support tabs.
■ ■ Glue the remaining pretrimmed L.E. sheeting to the
wing. Pin or tape to secure until dry.
■ ■ Fit and trim the T.E. sheeting and glue to the wing
NOTE: IF YOU ARE USING THE TWO-SERVO
OPTION, GO ON TO STEP 31.
24. ■ ■ Bend a 5/16” x 900 angle at one end of the .063
diameter x 20-3/4” wire pushrod.
■ ■ Install an aileron bellcrank onto the bend. (See plan for
correct orientation.) Secure with a snapnut. Place a
drop of JET glue on the snap-nut.