Carl Goldberg GBGA0055 - Manual (Page 33)

33
27. ■ ■ Locate Former “BB” at a 900 angle to the front
reinforcement and glue.
28. ■ ■ Glue one edge of the 1/32” ply TOP SHEET to the fuse.
Then, using a spray bottle to soak the sheet, slowly roll
to the opposite side, gluing as you go.
NOTE: MARK THE CENTERLINE ON THE TOP SHEET AND
THE FUSE TO INSURE A CORRECT FIT.
■ ■ Sand the edges in line with the firewall and Former “BB.”
29. ■ ■ Install Former “FF directly above Form “F” and at a 900
angle to the fuse top.
30. ■ ■ Mark the centerline onto the horizontal stabilizer and
on the stab platform of the fuselage.
■ ■ Glue the stabilizer to the platform, locating it on the
centerlines and against Former “FF.” Check the
stabilizer to insure that it is parallel to the base.