Carl Goldberg GBGA0055 - Manual (Page 32)

32
23. ■ ■ Flip the wing/fuse over and drill a small pilot hole (no
larger than 7/64”) through the wing.
■ ■ Remove the wing from the fuse and drill a 5/32” hole,
using the pilot hole as a guide.
■ ■ Test bolt the wing to the fuselage and check to make
sure the tip-to-tail dimensions are still equal.
24. ■ ■ Trim and glue the 1/2” balsa triangle stock behind the
firewall.
25. ■ ■ Glue in the top reinforcement.
26. ■ ■ Glue in the remaining triangle stock, as shown.