Carl Goldberg GBGA0055 User Manual

Page 18

Text mode
Original mode

15.

■

Glue the pretrimmed Trailing Edge part to the wing.
Align the “angle-cut” side with the notched T.E. Make
sure the top of the T.E. and the wing sheeting are flush
over the entire length.

REMOVE THE WING PANEL AND GO BACK TO STEP #3.
MAKING SURE TO WORK OVER THE OTHER HALF OF THE
WING PLAN. REPEAT THE CONSTRUCTION SEQUENCE
FOR THE OTHER WING PANEL.

AFTER COMPLETING STEP #15 FOR THE SECOND TIME,
GO ON TO THE NEXT STEP.

16.

■

Glue the front, rear, and tip wing fixture supports, as
shown.

17.

■

Locate the wing fixtures and pin to the plan. Align the
marks on the tip fixtures to the spar on the plan.

18.

■

Laminate the top and bottom portions of Rib #1.