Carl Goldberg GBGA0055 - Manual (Page 17)

17
11. ■ ■ Position a full sheet edge against the L.E. shoulder.
Align the corner with the L.E. centerline end and roll
onto spar.
■ ■ Mark the sheet in line with the top spar end and cut
along the line formed. Use this sheet as a template to
cut the other three L. E. sheets.
12. ■ ■ Glue the L.E. sheeting to the L.E. shoulder, ribs, and
spar, pinning or taping to secure until dry.
■ ■ Glue the 1/16 x 2-1/2 x 36” Trailing Edge sheeting to
the notched T.E. and the wing ribs.
13. ■ ■ To glue the center sheet in place, first install the front
and back pieces. Then, slide the center piece in tightly.
Trimming may be necessary.
■ ■ Place some glue on the wing tip sheeting and slide in
place.
■ ■ Cut the 1/16 x 1/4” balsa capstrips to fit and glue to the
wing ribs.
14. ■ ■ Trim the sheeting along the wing centerline.