Carl Goldberg GBGA0055 - Manual (Page 28)

28
7. ■ ■ Glue the wing-saddle doublers to the inside of the
fuselage sides. Reference the landing gear block area
and the wing curve for the correct alignment.
8. ■ ■ Glue the landing gear triplers onto the wing saddle
doublers. Make sure that the landing gear wire slots are
in line.
9. ■ ■ With the triplers face to face, tape the fuselage sides
together at the rudderpost end. Use a scrap piece of
3116” balsa spacer between the sides.
■ ■ Install Former “D” (balsa doubler forward) and secure
with a rubber band.
■ ■ Install Formers “E” and “F,” using rubber bands to
secure at each former.
10. ■ ■ Slide the fuselage top under the rubber bands and
press into position. Loosen the tape at the rudderpost
end to allow top to fit.