Carl Goldberg GBGA0040 - Manual (Page 20)

FUSELAGE CONTRUCTION
1. ‡ Collect the following parts:
(2) D/C SHT. 4003 Fuse Side PT. #3603
(2) D/C SHT. 4004 Fuse Doubler PT. #3604
(1) D/C SHT. 4005 Fuse Top PT. #3605
(1) D.C SHT. 4006 Dorsal Fin PT. #3606
(1) D/C SHT. 4007 Fuse Bottom PT. #3607
(1) D/C SHT. 4008 Ply PT. #3608
Containing:
Former “A”, Rear
Motor Mount, Polyhedral Joiners
(1) D/C SHT. 4011 Ply PT. #3611
Containing: Fuse bottom front,
Battery hatch, Hatch doubler, Hatch
tongue, Former “C” doubler
(2) D/C SHT. 4013 PT. #3613
(2) DOWEL 3/16x3-7/8” PT. #1748
(2) PUSHROD 1/4x1/4x17-7/8” PT. #4699
(2) HATCH RAIL 1/8x1/8x7-3/8” PT. #4875
(1) FLAT HOLD DOWN PT. #1434
(1) #2x3/16” PAN HEAD SCREW PT. #1085
(1) MOTOR MOUNT PT. #1665
(2) 10” THREADED ROD PT. #1272
(1) CLEAR CANOPY PT. #1628
(1) #2 x 3/16” SHOULDER SCREW PT. #1105
‡ Remove the die cut fuse parts and lightly sand
any rough edges.
‡ Place the fuse section of the plan over the
building board and protect with waxed paper.
2. ‡ Match the beveled corner edges of the hatch
tongue with the hatch corner. Note the vent
hole positions.
‡ When aligned, glue the tongue to the hatch.
3. ‡ Butt the fuse front bottom sheet against the
hatch and center it by aligning the die-marked
lines with the hatch sides, as shown.
‡ Carefully glue the fuse tongue to the fuse bot-
tom sheet. DO NOT GLUE TO HATCH PARTS!
Allow to dry.
20
FRONT BOTTOM FUSE
SHEET TONGUE
MATCH
TONGUE
CORNERS
D/C SHT. 4003 D/C SHT. 4007
D/C SHT. 4004
D/C SHT. 4008
D/C SHT. 4011
D/C SHT. 4005
D/C SHT. 4013
D/C SHT. 4006
HATCH MARKS