Carl Goldberg GBGA0040 - Manual (Page 19)

29. ‡ Cut a piece of 3/4” wide nylon long enough to
wrap completely around the wing with a small
overlap.
‡ Apply a spot of Super Jet™ on the wing bottom
at the center joint.
‡ Immediately stick one end of the nylon strip to
the wing and let dry until it is firmly glued to the
balsa.
‡ Before continueing, protect fingers with a plas-
tic bag or plastic wrap.
‡ Starting with the bottom of the wing, apply a
squiggle of glue along the wing joint and lay the
nylon strip over it.
‡ Rub the glue thoroughly into the nylon strip.
‡ Continue applying the nylon strip around the
L.E., across the top of the wing, around the
T.E., and finally overlapping where you started
on the wing bottom.
‡ Unless you have made the removable wing tip
option, repeat the above procedure, installing
nylon fabric at the polyhedral sheeting joints.
THIS COMPLETES THE WING ASSEMBLY. SET
ASIDE UNTIL IT IS TIME TO COVER.
19