Cabletron Systems SmartSTACK ELH100 - Manual (Page 97)

9033060 Web-Based Management 79
History Data Entry
Select “History” then “History Data Entry” to display the data recorded for
items in the history control table.
Item Description
History Index An index that uniquely identifies an entry in the History Control
table. Each such entry defines a set of samples at a particular
interval for an interface on the device.
History Indexes can include: 100 Mbps segment with samples
taken every 30 seconds, 100 Mbps segment with samples
taken every 1800 seconds, 10 Mbps segment with samples
taken every 30 seconds, or 10 Mbps segment with samples
taken every 1800 seconds.
Refresh Time Interval Interval at which data displayed to the screen is refreshed.
Sample Index An index that uniquely identifies the particular sample this entry
represents among all samples associated with the same history
control entry. This index starts at 1 and increases by one as
each new sample is taken.
Interval Start Value of sysUpTime at the start of the interval over which this
sample was measured.
Drop Events Total number of events in which packets were dropped by the
probe due to lack of resources during this sampling interval.
This number is not necessarily the number of packets dropped,
it is just the number of times this condition has been detected.
Octets Total number of octets of data (including those in bad packets)
received on the network (excluding framing bits but including
FCS octets).
Packets Number of packets (including bad packets) received during this
sampling interval.
Broadcast Packets Number of good packets received during this sampling interval
that were directed to the broadcast address.
Multicast Packets Number of good packets received during this sampling interval
that were directed to a multicast address. This number does not
include packets addressed to the broadcast address.