Cabletron Systems SmartSTACK ELH100 - Manual (Page 60)

42 ELH100-12/24TX User Interface ELH100-12/24TX
Module Port Configuration Menu
The switch/media module configuration menu is accessible only if a
module is installed in the hub’s upper slot. The switch/media modules
have two internal ports that are connected to the hub’s internal repeater
segments. The configuration screen and options are displayed below.
Figure 3-12. Switch/Media Module Port Administrative Status Control Menu
Port Administrative Status Switch/Media Module
==============================================
Hub ID: 1
Model: ELH100-12TX
Module Type: TX 10/100 Switch/Media Module
Port Admin State Link State Duplex Speed (Mb/s)
--- -------- ------- ----- ---------
1 Int: Enabled Link Half 100
2 Ext: Enabled Link Half 10
3 Ext: Enabled Link Full 100
Use the space bar to toggle between enabled and disabled states
Use or cursor keys to move, to toggle, to select
Selection Description
Module Type The type of module installed in the hub.
Port Port identifier for the module. Ports 1 and 2 link internally to
the hubs 100 Mbps and 10 Mbps repeater segments. Port 3
is the external port on the module’s front panel.
Admin State The module’s internal ports can be disabled to isolate the
module from the hub. You may wish to do this if the
module’s external connection is exhibiting abnormal
behavior or for security reasons.
Link State Indicates if the port has a valid connection.
Duplex The communication mode currently used by the port, either
half duplex or full duplex.
Speed Indicates the transmission speed currently used by the port.