Cabletron Systems SmartSTACK ELH100 - Manual (Page 32)

14 Installation ELH100-12/24TX
Mounting the Hub or Stack on a Table or Shelf
You can mount a standalone hub (or a stack of up to six hubs) on a table
or shelf. Locate the hub (stack) in a position that allows access to the front
panel RJ-45 ports, visibility of the port LEDs, and access to the power
cord. Make sure that the mounting surface can safely support the hub
(stack) and that there is adequate space around the hub (stack) for
ventilation and cooling.
1. The hub ships with four (4) rubber feet. Stick the self-adhesive rubber
foot pads on each of the four concave spaces located on the bottom
of the hub. The rubber foot pads cushion the hub against shock/
vibrations and provide space between each hub for ventilation.
2. If you want to stack hubs, repeat step 1 for each hub to be stacked.
Place the first hub on a firm flat surface where you want to install the
stack. Stack the other hubs on top of this unit.
3. Refer to "Connecting Hubs to the Stack’s Backplane" on page 16.