Port configuration menu, Port administrative status control menu – Cabletron Systems SmartSTACK ELH100 User Manual
Page 59

9033060
ELH100-12/24TX User Interface 41
Port Configuration Menu
Select Administrative Status Control from the Port Configuration screen,
then select the port group to configure, either “1 thru 12,” “13 thru 24,” or
“Switch/Media Module” (if installed). The following screens show the
configuration options.
Port Administrative Status Control Menu
Figure 3-11. Port Administrative Status Control Menu
Port Administrative Status Control (1 - 12)
===========================================
Hub ID: 1
Model: ELH100-12TX
Port
Admin State Link State Auto Partitioned
Mode
Speed (Mb/s)
---
-------- ------- -----------
----
-----------
1
Enabled
No Link
No
Auto
2
Enabled
No Link
No
Auto
3
Enabled
No Link
No
Auto
4
Enabled
No Link
No
Auto
5
Enabled
No Link
No
Auto
6
Enabled
No Link
No
Auto
7
Enabled
No Link
No
Auto
8
Enabled
No Link
No
Auto
9
Enabled
No Link
No
Auto
10
Enabled
No Link
No
Auto
11
Enabled
No Link
No
Auto
12
Enabled
Link
No
Auto
100
Use the space bar to toggle states
Use
Selection
Description
Admin State
Allows you to disable a port due to abnormal behavior such
as excessive collisions, and re-enable it after the problem
has been resolved. You may also disable a port for security
reasons.
Link State
Indicates if the port has a valid connection to an external
device.
Auto Partitioned
Indicates if the port is partitioned.
Mode
Sets the transmission speed to 10 Mbps, 100 Mbps or auto-
detection.
Speed
Indicates the transmission speed currently used by this port.