Cabletron Systems SmartSTACK ELH100 - Manual (Page 57)

9033060 ELH100-12/24TX User Interface 39
Figure 3-10. Hub Configuration Menu
Hub Configuration
=================
Hub ID: 1 Model: ELH100-12TX
Hardware ID: 11-00-00-00-1C-C8 Number of Ports: 12
10M backplane: Isolated 100M backplane: Isolated
SNMP Agent
==========
Status: Active H/W Ver: 0
POST Ver: 1.00 MAC Address: 00-00-1D-3F-2A-E1
System Ver: 1.00
Serial Port Baud Rate: 9600 Send Initialization String: NO
Serial Port Initialization String: ATQ0V0S0=1
Switch/Media Module
===================
Status: Not present
Isolate or attach the 10 Mb/s segment
Use or cursor keys to move, to toggle, to select,
to move forward a character, to move back a character
Selection Description
Hub Configuration
Hub ID Hub identifier in stack.
Hardware ID Serial number of this hub.
10M Backplane Attaches/isolates hub’s 10 Mbps repeater bus from the
stack’s data channel.
Model The model number of this hub.
# of Ports Indicates whether this device has 12 or 24 repeater ports.
100M Backplane Attaches/isolates hub’s 100 Mbps repeater bus from the
stack’s data channel.
SNMP Agent
Status Indicates if an Agent Module is installed and active.
POST Version Version number of the Agent Module’s Power-on Self-test.
System Version System firmware version.
Serial Port Baud Rate Rate at which data is sent between the Agent Module’s
serial port and the connected device. The supported baud
rate is 9600 bps.
Serial Port
Initialization String The modem initialization string sent from the serial port to
the attached device.
H/W Version Hardware version number of the Agent Module.
MAC Address Physical address of the Agent Module.