Canon L240 - Manual (Page 114)

9-2 Special Features Chapter 9
Special Dialling
Entering Pauses in a Fax/Telephone Number
You may need to enter pauses in a fax/telephone number in the following situations:
–
When you dial or register an overseas number. The length and position of the
pause depends on the telephone system of your country.
– When your FAX is connected to a switchboard. For details, see p. 3-9.
Follow this procedure to enter pauses during regular dialling or when registering a
number for speed dialling:
1
When you come to the step that requires you
to enter the fax/telephone number, use the
numeric buttons to enter the number up to
where a pause is necessary.
• If you enter the wrong number, press
Clear, then enter the correct number.
2 Press Redial/Pause to enter a pause.
• A pause entered within a number (p) is
two seconds* long.
• For a longer pause, press Redial/Pause
again for another two-second* pause.
Alternatively, you can change the length
of the pause (
MID PAUSE SET,
p. 14-6).
3 Continue entering the rest of the fax/
telephone number with the numeric buttons.
• If you enter the wrong number, press
Clear and start again from step 1.
4
To enter a pause at the end of the number,
press Redial/Pause.
• A pause at the end of a number (P) is
fixed to ten seconds.
5 Continue with the operation you are
performing.
TEL= 00 Ex:
TEL= 00P Ex:
TEL= 00p811234 Ex:
TEL= 00p811234P Ex:
* The duration of a pause varies depending on the country.