AERCO C-More Controls - Manual (Page 41)

C-MORE CONTROL PANEL OPERATION
37
Stepper Test
the Air/Fuel Valv
▼ arrow key until Stepper
key. Stepper Test w
the ▲ arrow key to increment
y to
6.3.6 Sensor Log Int
tion permits the
to values ranging from 1 minute to 24 hours.
og
Int Off is displayed.
layed. The available choices
ired interval displayed, press
re the selection in memory.
The Stepper Test allows e
user to set the interval at which sensor readings
are recorded and stored in memory. By default,
this option is set to OFF. However, if desired,
the Sensor Log Interval can be enabled and set
. Press the ▲ or ▼ arrow key until Sensor L
Stepper Motor to be rotated between virtually
any position between 0% (fully closed) and
100% (fully open).
1. Press the ▲ or
3.
Test 0% is displayed.
2. Press the CHANGE ill are:
(a) 1 Min
begin to flash.
3. Press and hold
the Stepper Motor position. The FIRE RATE
bargraph will increase to show the valve
position and the dial on the Air/Fuel valve will
also rotate to track the current position.
4. Press and hold the ▼ arrow ke
decrement the Stepper Motor position and
verify that bargraph display and Air/Fuel
Valve dial track the change.
The Sensor Log Interval func
1
2. Press the CHANGE key. Sensor Log Int will
begin to flash.
Press the ▲ arrow key until the desired
interval is disp
(b) 5 Min
(c) 15 Min
(d) 30 Min
(e) 1 hr
(f) 6 hrs
(g) 12 hrs
(h) 24 hrs
4. With the des
ENTER to sto
5. Press BACK to exit the Sensor Log Int
function.