AERCO C-More Controls - Manual (Page 11)

C-MORE CONTROL PANEL OPERATION
5. Continue pressing the ▲or ▼ arrow key until
the desired menu option is displayed.
Pressing the ▲ arrow key will display the
available menu options in the Top-Down
sequence. Pressing the ▼ arrow key will
display the options in the Bottom-Up
sequence. The menu options will wrap-
around after the first or last available option.
6. To change the value or setting of a displayed
menu option, press the CHANGE key. The
displayed option will begin to flash. Press the
▲ or ▼ arrow key to scroll through the
available menu option choices for the option
to be changed. The menu option choices do
not wrap around.
7. To select and store a changed menu option,
press the ENTER key.
NOTE:
Paragraphs 2.3 through 2.8 provide brief
descriptions of the options contained in
each menu. Refer to Section 3 for detailed
descriptions of each menu option.
2.3 OPERATING MENU
The Operating Menu displays the unit status and
a number of key operating parameters for the
unit as listed in Table 2-1. This menu is “Read-
Only” and does not allow personnel to change or
adjust any of the displayed items. Since this
menu is “Read-Only”, it can be viewed at any
time without entering a password. Press the ▲
arrow key to display the menu item in the order
listed (Top-Down). Pressing the ▼ arrow key
will display the menu items in reverse order
(Bottom-Up).
2.4 SETUP MENU
The Setup Menu (Table 2-2) permits the
operator to set the unit password which is
required to change any of the menu options. To
prevent unauthorized use, a previously entered
password entry will time-out after 1 hour.
Therefore, the password must be reentered
when required. In addition to permitting
password entries, the Setup Menu is also used
to enter date and time, language to be used for
display messages, units of temperature
measurements and entries required for external
communication and control of the unit via the
RS232 port. A view-only software version
display is also provided to indicate the current
Control Box software version,
NOTE
The Outdoor Temp display item shown with an asterisk in Table
2-1 will not be displayed unless the Outdoor Sensor function has
been enabled in the Configuration Menu (Table 2-3).
Table 2-1. Operating Menu
Available Choices or Limits
Menu Item Display Minimum Maximum Default
Status Message
Active Setpoint 40°F 240°F
Aux Temp 30°F 245°F
Outdoor Temp* -70°F 130°F
Fire Rate In 0% Max Fire Rate
Flame Strength 0% 100%
Run Cycles 0 999,999
Run Hours 0 999,999
Fault Log 0 9 0
7