AERCO C-More Controls - Manual (Page 25)

C-MORE CONTROL PANEL OPERATION
21
.2
Table 4-1. Startup and Status Messages
SECTION 4 -
CONTROL PANEL DISPLAY MESSAGES
4.1 STARTUP & STATUS MESSAGES.
Startup and status messages are displayed on
the VFD display on the front panel of the C-More
Control Panel. This display is comprised of two
lines with 16 characters per line. The startup and
status messages which may appear in the
display are listed in Tables 4-1.
4
FAULT MESSAGES.
Fault messages which may appear in the VFD
display are listed in Table 4-2.
MESSAGE DESCRIPTION
DISABLED
HH:M D/YY
ay also
M pm MM/D
Displayed if ON/OFF switch is set to OFF. The displ
shows the time and date that the unit was disabled.
STANDBY
and date are also
Displayed when ON/OFF switch is in the ON position, but
there is no demand for heat. The time
displayed.
DEM AY AND DEL
XX sec
Displayed if Demand Delay is active.
P
XX sec
URGING Displayed during the purge cycle during startup. The
duration of the purge cycle counts up in seconds.
IGNI IAL
XX sec
TION TR Displayed during ignition trial of startup sequence. The
duration of cycle counts up in seconds.
FLAME PROVEN
ed, the time and date are shown in place
Displayed after flame has been detected for a period of 2
seconds. Initially, the flame strength is shown in %. After 5
seconds has elaps
of flame strength.
W he initial warm-up only. ARMUP
XX sec
Displayed for 2 minutes during t
WAIT Prompts the oper tor to wait. a