AERCO Modulex EXT 321 - 1123 - Manual (Page 76)

MODULEX EXT 321, 481, 641, 802, 962, 1123 BOILERS
Installation, Operation & Maintenance Manual
Table 3-7: MODULEX EXT FA (Factory) Parameters Set in PARAM HS xx Menu
Parameters
MODULEX EXT
For Low Altitude For High Altitude
FAN MOD IGN 80 No Change
FAN MOD STBY 26 No Change
FAN MAX (FH) 91 78
FAN MIN (FL) 31 No Change
MAX DIFF PRO 30 No Change
MIN FLOW PRO 00 No Change
MIN FLOW RAT 200 No Change
BOIL HYS 5 No Change
BOIL SLP LIM 10 No Change
BOIL P VAL 25 No Change
BOIL I VAL 12 No Change
BOIL D VAL 00 No Change
PUMP OVERRUN 05 No Change
PUMP MIN MOD ---- ----
CAP FLOW RATE ---- ----
FAN P VAL 04 No Change
FAN I VAL 08 No Change
FAN SLP
FAN SLP POS ---- ----
FAN SLP NEG ---- ----
FAN START PW ---- ----
FAN ADAPT ---- ----
RESTARTS ---- ----
SW NO Software N° Software N°
SW RWV Software Revision Software Revision
3.36 High Altitude Conversion Label
After calibration of the unit from Normal Altitude (0 - 2,000 feet) to High Altitude (2,000 –
4,500 feet) operation, the label below must be filled out with the appropriate information
and applied to the unit in close proximity to the rating label. If the unit is calibrated again
for normal altitude operation, the label should be removed.
Figure 3-41: High Altitude Conversion Label
Page 76 of 148 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0087_0E
12/01/14 Phone: 800-526-0288 GF-143