Holtgreven GSE-375 - Manual (Page 82)

76
3. Navigate the Setup Mode as described in Setup Mode on page 16.
To exit the Setup Mode:
1. Press [ZERO]
2. Press [SAMPLE/Enter].
I NFORMATION M ODE P ARAMETERS (370 AND 375)
A series of informational parameters are available beginning at P60000. These parameters may
be accessed from the Setup Mode, or from the Weigh Mode as described below. Table 5-1 gives
an explanation of each information parameter.
To access the informational parameters:
1. Press 60000 [SELECT].
DISPLAY READS P60000 ~ E2Ins ~ 512
2. Navigate the Setup Mode as described in Setup Mode on page 16.
As each information parameter is accessed, the parameter number is briefly displayed, followed
by the parameter name, and finally the parameter value. To repeat the parameter number and
name sequence, press [SELECT]. To exit the information mode, press [ZERO].
Table 5-1: Information Parameters
PARAMETER NAME DESCRIPTION
60000 E2Ins Total amount of EEPROM storage.
60001 E2Fre Amount of available EEPROM storage.
60090 SPEEd
Set and view the microprocessor speed. The higher the speed of the
processor, the more power consumption. The default value is 3.69 MHz.
Press the [TARE]
key on the 370 or [SAMPLE/Enter] key on the 375 to
change the value. The value will not take affect until power is cycled. View
the current processor speed by pressing [PRINT] or [UNITS]
60100 -GSE- ~ c1998 Copyright statement.
60101 0370P ~ 01001 Firmware revision code.
60102 02- 10 ~ 1998 Firmware date code.
60200 b sn ~ 10001 Main circuit board serial number.
60201
Audit ~ Trail
Euro ~ 00000
OIML (European) audit trail number. Does not apply to the Model 370/375.
60202 i sn ~ 00000 Model 370/375 serial number.
60203
Audit ~ Trail
CAL. ~ 00000
Calibration audit trail number. Does not apply to the Model 370/375.
60204
Audit ~ Trail
Setup ~ 00000
Setup audit trail number. Does not apply to the Model 370/375.
61100
Load ~ Cell
0.00000
Current mV/V output of the load cell.
61101
Cal ~ Factr
1.00000
Calibration factor for the load cell.
61102
Rezro ~ Load
0.00000
Amount of weight (in default units) zeroed through use of the [ZERO] key.
61103
Zrtrc ~ Load
0.00000 Amount of weight (in default units) zeroed by the zero track feature since
[ZERO] was last pressed.
61104 CZero ~ 0P Coarse zero calculated during calibration.
61105
Fine ~ Zero
1738
Fine zero calculated during calibration.
61106 CGain ~ 50 Coarse gain calculated during calibration.
61107
Fine ~ Gain
1.00000
Fine gain calculated during calibration.
61110
61112
Zero ~ Adj25
73741
Zero ~ Ad100
-21813
A/D compensation for coarse zero.