Canon MPC600F/400 - Manual (Page 40)

4-12
4 Press Start to begin scanning for sending, or wait a few seconds for the machine to begin scanning
automatically.
• The machine will first send the document to the one-touch speed dialling destinations, then the coded speed
dialling destinations, and finally to the destination dialled using regular dialling.
• If you prefer the machine never to scan a document automatically after a few seconds, disable the TIME OUT
setting. (
→
p. 9-5)
• To cancel sending, press Stop/Reset then . Sending to all destinations you specified in step 3 will be
cancelled (you cannot cancel only one destination), and the machine will print a MULTI TX/RX REPORT.
(
→
p. 7-4)
• If a number is busy, the machine will continue sending to the other destinations and then redial the number that was
busy.
• If the machine’s memory becomes full while scanning your document, MEMORY FULL will appear in the LCD. If
this happens, remove the other documents from the ADF, and then press Resume . The document remaining in the
ADF will be ejected automatically. Divide the documents into several sections and send each section separately.
• If you send a colour document to a fax machine that does not support colour faxing, or TRY AGAIN IN B&W
displays in the LCD, → p. 4-1.