COP-USA DVR5104DE-HWDWF - Manual (Page 69)

) ---MCMS Remote Surveillance---
Mobile DVR User Manual
63
Chapter 7
‹ Local Alarm Configuration
A user can configure the MCMS for recording based on a sensor alarm or video loss alarm. In the ‘Local Configuration’ interface,
select ‘Local Alarm Config’ tab.
Configuration Steps
Select a channel from the device list and then select the ‘Alarm Type’
Once an alarm type has been selected, the user can trigger ‘PC Audio Alarm’, E-map, or Channel Recording.
A particular alarm can be set to trigger a local sound alarm on the MCMS. Sound alarm can be triggered by sensor alarm, video
loss and so on.
Map Alarm refers to triggering an alarm on the Map. Once an alarm has been linked to a Map, the selected channel/camera
would appear the alarm state in the Map.
The user can also trigger recording of channels using alarm inputs. From the device list select the device and configure the
Alarm Input (Sensor) and the trigger mode. This can be set to raise a PC Audio Alarm or/and record channels.
7.4.3 Server Configuration
The customer can configure a MDVR using the Server Configuration interface. Please refer to Chapter 4.for more details.
7.4.4 User Manager
An administrator can add several users and set the access rights for each user.
To add users to operate the MCMS, please enter Into ‘System ConfigurationÆUser Manager’ interface.
‹ Add User
Note: In order to select sensor based recording/alarm, please select the device from the
device list and the sensors would be displayed in the ‘Alarm type’ box.