Chapter 7 – COP-USA DVR5104DE-HWDWF User Manual
Page 60

)
---MCMS Remote Surveillance---
Mobile DVR User Manual
54
Chapter 7
A user can choose to output the signal on a secondary monitor by selecting \\.\DISPLAY2. When output is displayed on the
secondary monitor, the user can continue with other activities on primary monitor.
In the device list box, right click a certain channel. A shortcut menu will be shown as follows:
Turn off the live:
Clicking this item will close present live preview.
Start Manual Record:
Select a channel and click Start Manual Record, this channel will start to record.
Click “Stop Manual Record” and the channel will stop recording.
Enable audio:
After this item is enabled, the voice can be heard from live.
In the device list box, right click a device name. A shortcut menu will be shown as follows:
Talk:
Two-way talk between device end and CMS client.
Turn off All Live:
Clicking this item will close all channel images of this device.
Device Config:
Click this item to configure the device remotely.
GPS only:
Select it to show the position of vehicle but not to display live images.
In the device list box, right click the upper level name to display a shortcut menu as shown below:
Turn off All Live:
Clicking this item will close live images of all devices listed under this upper level
name.
GPS only:
Select it to show the position of vehicle but not display live images.
Select a screen mode and then drag the device to the map as shown below: