Chapter 4 – COP-USA DVR5104DE-HWDWF User Manual
Page 40

)
---Main Menu Setup Guide---
Mobile DVR User Manual
34
Chapter 4
4.5.6 Other Alarm
This tab gives a choice to co nfigure alarm for Disk Full or IP conflict or the
Disconnect event.
Step1: Enter into system configurationÆother alarm; refer to Fig 4-27
Step 2: Use the dropdown menu and select the event for the alarm.
Step 3: Check the required trigger options.
Buzzer:
If selected, the local buzzer would be activated on an alarm.
To Alarm out:
If selected would trigger the inbuilt relay on the set event alarm.
If the selected event is “Disk Full”, then use the drop down box for “Disk
Fig4-25 other alarm
Shortage Alarm” to choose a threshold value for remaining HDD space. If the threshold value is reached, the system will trigger
the Disk Full Alarm.
Step 5: Click “apply” button to save the settings; click “exit” button to exit current interface.
4.5.7 Alarm Out
Alarm out includes three sub menus: Alarm out, Schedule and Buzzer
ķ
ķ Alarm Out
Step1: Enter into System configurationÆAlarm out. Pl ease refer to F ig
4-26:
Step2: In this interface, set relay alarm out n ame and select hold time
which means the interval time between the two adjacent alarms.
Step3: Select All to setup all channels with the same parameters.
Step4: Click “default” button to reset to the default setting; click “apply”
button to save the settings; click “exit” button to exit current interface.
Fig 4-26 system configuration-alarm out
ĸ Schedule
Step1: Enter into System configurationÆSchedule;